|
|
Swimming pool water heater from 6KW-35KW(single phase to 3-phase),With high quality titanium heating exchanger for pool water, anti-corrosion case,standard ISO water inlet/outlet connection,Larger screen LCD wire controller or panel controller,air purger valve,anti-freezing protection, pressure prootection, easy open panel for easy maintenance. R407C/R410A Environmental protection gas.5~7 water temperature difference between inlet/outlet water. Low noise operation unit.
|
|
Function
Auto operation mode
Cooling&heating
Auto-restart, Auto defrost
LCD Control
Features
Wide range user: -10`43
Powerful heat transfer and low running cost
Titanium heat exchanger
Japanese brand compressor
Green refrigerant R410
|
|
Swimming pool heating installation. It uses night rate electricity in hotel complexes, sports centres, clubs, private homes, buildings, and so on.
This energy is the most economical, safer, reliable and the least polluting.
Maximum heating time is 8 hours (23h-7h is the normal night rate tariff). If you heat up for 24 hours a day, you should divide by 3 the power shown on the table.
This is the consumption during the coldest day. The rest of the time, the consumption will be lower than the one shown on one on the table.
The information appearing in "Technical data" is only valid for outdoor swimming-pools when the outside temperature is not below 15C.
|
|
Slash pool heating costs to pennies per day
With ThermalFloTM Heat Pumps, heat from the atmosphere is transferred to your pool or spa, providing the most energy efficient heating available. ThermalFloTM Heat Pumps are our latest and most technologically advanced heat pumps, offering more standard features than any other.
An Eco SelectTM Choice: ThermalFloTM Heat Pumps heat pumps transfer heat from the atmosphere to the pool or spa, saving up to 80% in energy costs compared to gas-fired heaters. Plus, they are the only heat pumps available that use R-410A refrigerant-EPA-recognized as environmentally safe and clean.
Features
-100% pure titanium heat exchanger assures corrosion - free performance for extra long life.
-New LCD control board displays an intuitive menu-driven read out with easy to follow full word messages - no more codes.
-Digital controls with dual thermostats offer precise temperature control to maintain the desired separate water temperature in pool/spa combinations without overheating or wasting energy
-Compatible with all automated control packages
-Long-life corrosion resistant plastic composite cabinet stands up to severe climates and pool chemicals
-High efficiency TraneTM compressor is the most energy efficient, durable, and quiet compressor available
-ETL listed for safe operation
-Autoset (Time Clock Override) feature monitors water temperature and turns the water circulation pump on and off as needed to maintain desired pool temperature.
-Thermostatic Expansion Valve (TXV) controls refrigerant for optimum efficiency and BTU output over a wider operating range.
-Automatic defrost feature senses refrigerant temperature and prevents ThermalFlo from freezing, allowing the heat pump to operate at even lower temperatures
|
|
Description
The PowerMax Commercial pool heater models 525, 750 and 900, are designed for indoor and outdoor installation. All these models operate with an electronic ignition natural gas fuel. All heaters are equipped with two thermostats on the front of heater control panel.
Featured Highlights
-525,000 - 750,000 and 900,000 BTU models available
-The selector dials eliminate constant thermostat adjustments
-Six indicator lights for easy operation
-Bronze Headers
-All ASME certified
|
|
|
For each 1 kW CLIMEXEL consumes, it generates at least 4. This is among the highest yields available today. The explanation lies in its titanium plate heat exchanger: the exchange surface area of a plate is higher than that of a tube, hence more calories are captured and the yield is increased. Consequently, it is one of the most economical pumps available on the market. As regards titanium, this stable material is totally compatible with every type of water treatment, including salt electrolysis.
|
|
Boiler rooms SKP (SuperKit Pool) associate a boiler
electric with a plate heat exchanger in INOX316L.
Heaters not n%u2019tant in contact with
water of pool, these boiler rooms can be installed on
all types of basin: chlorinated water, treatment by salt, water
of sea, %u2026 without fearing corrosion.
The determination of boiler rooms SKP always makes l%u2019objet
d%u2019une particular study according to the communicated data
at our writing desk d%u2019tudes.
The delivered apparatuses are thus %u201Cprts with poser%u201D and easy with
to implement.
ELECTRIC BOILER ROOM "TURN-KEY"
Power and reliability!
Integrated Electric boiler rooms
Cable lengths Electrically and Hydraulically
Total separation of the circuits for more reliability (with plate heat exchanger STAINLESS or TITANIUM)
Units ready to pose integrating the regulation of the basin
Electric wardrobe of complete order integrating of the functions of remote control, unballasting, etc... Pools
|
|
The air which surrounds us is inexhaustible and free. Each day the sun brings its heat to him. Because you do not have surface
necessary to pose its sensors POLYTUB, giordano another economic solution proposes to you: heat pump GIORPAC.
The principal characteristic of an heat pump is to draw the calories contained in the air while consuming on average 1/4 to 1/3 of the energy which it brings. Thus when a GIORPAC brings 3 to 4 kWh to your pool, meter EDF invoices you only 1 kWh.
|
|
The air which surrounds us is inexhaustible and free. Each day the sun brings its heat to him. Because you do not have surface
necessary to pose its sensors POLYTUB, giordano another economic solution proposes to you: heat pump GIORPAC.
The principal characteristic of an heat pump is to draw the calories contained in the air while consuming on average 1/4 to 1/3 of the energy which it brings. Thus when a GIORPAC brings 3 to 4 kWh to your pool, meter EDF invoices you only 1 kWh.
|
|
Heat pump for heating maximum swimming pool 50 m3, private basin.
Order by black box connected to the pump by a cable.
Guarantee 2 years.
Power supply 220 V. absorptive Power: 1,7 kw
Weight: 66 kg
|
|
Completely autonomous hot air generator designed for conditioning covered swimming pools. This equipment can operate with heating gas oil, natural gas or liquefied petroleum gases (butane gas, propane gas).
These equipments function is to heat environmental air inside the premises by means of the thermal energy produced by the equipment.
The produced heat is driven to the premises that must be conditioned by means of a centrifugal fan.
The combustion products are extracted through a chimney in order to ensure that the driven hot air is exempt of smokes and bad smells.
The main features are as following:
-Heating gas oil, natural gas or liquefied petroleum gases operation.
-Cupboard made with galvanised sheet covered with polyester dust dried in the oven at 200C.
-Combustion oven designed for obtaining a performance of 90%.
-Three-speed centrifugal fan.
-Electronic control with a display of the temperature driven to the premises.
-Environmental thermostat incorporated in the equipment.
-Air impulsion in elbow shape at 90 with double deflection grid incorporated on it.
-It incorporates a digital time-programmer for starting-up and stopping automatically the equipment.
-Extractible air admission filter.
FUEL:
Heating gas oil / natural gas /LPG
APPLICATIONS:
Covered swimming pools, events tents, small industry and any premises with a volume between 750m3 and 1.075m3 approximately.
|
|
|
Electric heater 1,5-3,0 kWPahln electric heater is designed for continuous flow with the lowest possible pressure drop. The compact dimensions make it suitable for spa pools, small swimming pools and installation in restricted spaces. The heater is manufactured from acid-proof stainless steel AISI 316. It is available in three sizes of 1,5 kW, 2,0 kW or 3,0 kW and is fitted with an adjustable thermostat 0-45C together with automatic over heating protection.
|
|
|
Pahln Hi-Flow titanium is a heat exchanger with excellent heat transference capabilities. The unit is intended for swimming pools and other applications where there is a demand for high flow rates together with a low-pressure drop. Titanium is chosen for its high resistance to corrosion and is therefore suitable for pools and spas with aggressive water, salt water and where a salt chlorinator is used. The titanium heat exchanger is light and compact with welded jackets and pipe system for the transfer medium. Titanium heat exchangers can be installed together with boilers, heat pumps, solar panels or other heat sources.Maximum pressure: Primary 30 bar - Secondary 5 bar.
|
|
Heat exchanger for swimming pool water heating.
Heating tube array made from high-alloy stainless steel
With fitted thermal insulation
|
|
Solar Power
The sun is the ideal source of energy to heat water in swimming pools: comfortable, reliable and perpetual. At the same time, the sun also contributes substantially to the reduction in the costs of energy, because less gas is required to heat the water.
Various swimming pool owners have already discovered that the use of solar power gives benefits:
- Lower energy costs because the heating boiler provides no or little additional heating.
- The use of solar power is an environmentally-friendly way of heating the water in swimming pools.
- Extension of the swimming season by two months (in comparison to an unheated open-air pool).
In addition, solar-power systems require little or no maintenance. Opting for a solar-power system therefore means opting for future-orientated and cost-effective technology, without making concessions in terms of comfort.
Solar Collector: heat all of the time!
The most important part of a solar-power system is the collector, which converts sunlight into heat. Collectors can be placed either on the roof or on the ground. Even when the sky is cloudy, the collectors are still able to supply heat. They have, in fact, been built in such a way that they convert light into heat. If the sun shines in abundance, the water will heat up quickly. If it is cloudy, it will take a little longer for the water to reach the required temperature. Collectors supply sufficient heat to, for example, keep an outside pool at a pleasant temperature for almost the whole swimming season, or to contribute to heating the water in an indoor swimming pool throughout the year.
|
|
Specially designed for pool water heating, available both in AISI 316
stainless steel with mirror finishing and - for some sizes - in silver coloured
lacquered titanium.
Electro-welded outer body with water flow coil and control drain for
temperature measuring
Max operating pressure:
- Heating circuit 10 bars
- Pool circuit 3 bars
|
|
Electric heater equipped with a titanium resistance (3kw mono/three). Thermal overload protection (light signal) in case of overheating. ON/ OFF light switch. Mechanical thermostat to adjust temperature. Electric cable & switch.
|
|
The CLIMEXEL heat exchanger is designed to be
mounted in by-pass with a boiler or heat pump as
the heat source. It may be purchased as is or,
alternatively, pre-assembled with the circulating
pump and every other element required for its
operation contained within an ingeniously designed
housing.
This heat exchanger features spiral plates made
of titanium, a very stable metal, that generate an
excellent yield thanks to the large exchange surface
area.
The pre-assembled version of the heat exchanger
is ready to plug and play, it simply needs to be
mounted on the filtration circuit.
|
|
Today, solar energy is the only economic means which makes it possible to double the period of use and to improve comfort of the pools. Range POLYTUB adapts to all the situations (terrace, gardens, roofings, etc) and to all the budgets.
1 - POLYTUB S - For an installation on the ground
Flexible solar collector POLYTUB "S" is particularly intended for the installations to measure.
The matter used (EPDM) in its manufacture brings the flexibility necessary to him making it possible to marry all surfaces whatever is their form (big lengths, roofs with several slopes, triangles, hillocks of ground, large terraces...).
Proposed in rollers, the POLYTUB "S" can be cut out to adapt to the type of surface you have.
2 - POLYTUB M - For installations on roofing
Modular solar collector POLYTUB "M" is especially designed for installations on roofing.
The matter used (Polypropylene) in its manufacture, confers rigidity to him allowing a good behavior and an excellent esthetic aspect.
The originality and the quality of its design allow a fast and simplified installation.
3 - Principle of operation of Polytub
Two types of connections are proposed: automatic or handbook, according to the typology of the pool and of its use.
|
|
Modular solar collector POLYTUB "M" is especially designed for installations on roofing.
The matter used (Polypropylene) in its manufacture, confers rigidity to him allowing a good behavior and an excellent esthetic aspect.
The originality and the quality of its design allow a fast and simplified installation.
|
|
| ... products without information |
| |
|
|