Boilers with heat exchanger(s) get its heating energy from solar collector or central heating system and produce potable hot water. Fluid in the serpentines provides heat transfer water to water via transferring its heat energy to water in inner tank. Thus potable hot water will be produced.
Cylinder type hot water tank and serpentines are coated with immersing to hot galvanize. Thus anode rod is not needed and you save your time and cost for changing anode rod. Due to special coating material heat transfer is faster and heating efficient is high.
You can observe water temperature with thermometer. You can set desired temperature with adjustable thermostats. When water temperature has achieved desired temperature, thermostat will send a signal then circulation and recirculation pumps will be out off service. Thus it will prevent waste operation.
DCSB and DTSB series boilers are available for additional heating elements. Thus, especially in summer periods you can provide hot water with electrical supply without using central heating system. If you use DCSB-X and DTSB_X Series model with electrical command panel ask for temperature pressure valve which provides discharging excess water/steam pressure and temperature.
Vitocell cylinders deliver hot water quickly on demand, with only around 1'C of heat loss during a 24 hour period.
Hi-grade stainless steel ensures a long service life and very low heat loss. The large dimensioned heat exchangers reach right to the cylinder floor, to heat the entire water content.
This sophisticated further development of the thousand fold proven Ökocell triple zone tank can be flexibly used and will impress you with its high performance. Due to the high efficiency of the heat exchanger surface area, the H3 uses the flow principle to deliver sufficient fresh hot water of extraordinary quality - every time.
The stainless steel corrugated pipe element with a large heating area replaces the hot water tank. The H3 is best combined with wood, oil or gas heating systems. Treat yourself to this added quality of life and health!
Today hot water is taken for granted in every household. Whether for showering, bathing or cooking, the uses for hot water are many and varied. The danger for health which can arise through hot water are considerable and should not be underestimated.
The solar hot-water heater with forced circulation consists from one to three solar collectors, a balloon of storage and a power transfer unit GIORSOL. Traditional, this system uses a liquid antifreeze as coolant to recover the energy absorptive by the sensors and to transmit it via an exchanger, with the balloon of storage.
- Standard solar hot-water heater GIORSOL is very FUNCTIONAL: several indicators of control make it possible to check the good performance of the installation permanently.
- It is FLEXIBLE: Jacques giordano industries proposes a broad range of hot-water heater GIORSOL going from 100 liters to 550 liters, likely to adapt to various configurations: vertical or horizontal sensors, balloons manufactured with an enamelled coating or out of stainless steel.
The solar hot-water heater with forced circulation consists from one to three solar collectors, a balloon of storage and a power transfer unit GIORSOL. Traditional, this system uses a liquid antifreeze as coolant to recover the energy absorptive by the sensors and to transmit it via an exchanger, with the balloon of storage.
