Patterned printed glass panel
PATTERN 62 ARCH Aluminum & Glass Co., Inc.

Traditionally pattern glass products have been used to obscure vision areas requiring privacy but allowing virtually the same light transmission as clear glass. The level of obscurity depends on the pattern which has been imprinted into the glass as it is made. This process of rolling the still hot and soft glass imparts a 3 dimensional texture to one side. The opposite side is relatively flat. The most common use of pattern glass is office screening, decorative partitions, rest room facilities, patio furniture, shower doors and entryways. Arch Aluminum stocks a wide variety of pattern glass from 1/8" up to and including 1/2" thicknesses. We can provide a single cut size lite, case quantities, or whole truck loads depending on your needs. Traditionally there are many different patterns that have been produced by a variety of manufacturers. Some patterns may no longer be produced or available in limited quantities only. Not all patterns or processes are available in all locations but our network of branches across America can ship virtually anywhere. Available with common fabrication for holes, notches and hinge cut outs. These products are typically available as both tempered and insulated. Not all patterns are available at each location. Contact your local Arch representative for availability, limitations and leadtimes.

Favorites

Other ARCH Aluminum & Glass Co., Inc. products

PATTERN GLASS

INSULATED

HEAT TREATED

SPANDREL

MIRRORS

SILKSCREEN GLASS

WARDROBE DOORS

DECORATIVE

LAMINATED GLASS

PASSIVE LOW-E'S

SOLAR CONTROLLED LOW-E'S

ENTRANCE DOORS

SLIDING WALL SYSTEMS

HARDWARE

STOREFRONT

CURTAIN WALL SYSTEMS

RESISTOR PROTECTION SERIES