MAIN FEATURES
• Analogic/Digital convertor, 4 channels
• Standard measuring range 0-10 V
• Not stabilised 15V power supply capable of supplying a maximum of 20mA (100 mA when connected to an external power supply (12~18V) trough the Jack connector)
The device NetMan Sensor Interface enables you to connect to the SNMP the irradiance and temperature sensor ((XPV3RS01A and XPV3RS02A)). This allows to monitor the measurements through the supervision software SunVision.
INTRODUCTION
The accessories described in this manual are of the highest quality, carefully designed and
built in order to ensure excellent performance.
This manual contains detailed instructions on how to install and use the product.
It should be kept with care near the device, so that it can be consulted for information on
how to use and make the most of your device. IT SHOULD BE READ BEFORE YOU
START WORKING ON THE DEVICE.
SAFETY
This part of the manual contains SAFETY precautions that must be followed
scrupulously.
The device has been designed to operate only in closed environments. It should be
installed in rooms where there are no inflammable liquids, gas or other harmful
substances.
Take care that no water or liquids and/or foreign bodies fall into the device.
In the event of a fault and/or impaired operation of the device, do not attempt to repair it
but contact the authorized service centre.
The device must be used exclusively for the purpose for which it was designed. Any other
use is to be considered improper and as such dangerous. The manufacturer declines all
responsibility for damage caused by improper, wrong and unreasonable use.