Cantilever sliding gate BETAFENCE
Sliding gate ROBUSTA®

Robusta cantilever sliding gates are either manually operated or automated with Betafence Motorisation. The total roll system is integrated in the under beam guaranteeing security and safety. Robusta cantilever gates are fully pre-assembled in the factory to allow quick and easy installation on site. Gates are galvanised inside and outside, after this an adhesion coating is applied then the gates are plastic coated.
Robusta 2000 - 3m up to 9m free passage
Gate wing
- Welded structure.
- Distance between the vertical bars: 110 mm.
- Provided with a cylinder lock (for manual gates).
- Security topping optional for all heights.
- The frame is provided at the top and the bottom with guiding rolls for a perfect entering in the end post bridge.
- Two sets of rolls in the underbeam for horizontal and vertical guiding.
- Both sets have a brake system to guarantee a smooth closing of the gate.
- Some types of gates have a roll to support the gate in open condition.

Guiding of the gate
- Guiding posts bridge and end posts bridge with welded ground plates.
- The guiding posts bridge has 2 guiding rolls at the top and an integrated foot plate for the installation of 1 roll set that is situated in the underbeam.
- Special guiding posts bridges with integrated electronics are used for motorisation.
- The end posts bridge of the not motorised gate has a lock system integrated in the gate catcher.