Antimicrobial PVC wallcovering
BIOCLAD
BioClad Hygienic Wall Cladding
BioClad internal cladding is a very versatile system which can be easily installed in almost any building.
Wall Preparation
Walls should be level and flat. Remove high spots and fill low spots. Advanced adhesive can be applied to any solid wall or wall surface, eg plaster, gypsum, board, brick, poured concrete, concrete block etc. it can also be applied directly to tiled surfaces that are firmly fixed to the wall. All surfaces must be dry and clean.
Cutting
A jigsaw is the best method of cutting the sheeting panels. A fine toothed hand saw can also be used to cut the panels.
Jointing
Fully sealed joints are made using Advanced high impact PVC Silicone free gasket trim system which incorporates a co-extruded seal unique to Advanced. Joints can also be welded upon request.
Internal / external corners
Advanced PVC is normally thermoformed on site, so window and door reveals are neatly clad without an edge joint.
Fixing
Panels are fixed using a fully bonded method with a trowel for advanced adhesive (or gun applied polymer adhesive subject to wall substrate).
Advanced Panel Adhesive
This provides a quick and simple method to fit hygienic PVC panels to most substrates. This polyurethane adhesive is applied to the back of the panels or onto substrate to give a solid all over bond.
The adhesive is easy to spread and should be applied with a notched trowel (see diagram). To ensure a 100% transfer of adhesive, apply firm, even pressure to the complete surface area when the panels are offered to the wall.
Wall Preparation
Walls should be level and flat. Remove high spots and fill low spots. Advanced adhesive can be applied to any solid wall or wall surface, eg plaster, gypsum, board, brick, poured concrete, concrete block etc. it can also be applied directly to tiled surfaces that are firmly fixed to the wall. All surfaces must be dry and clean.
Cutting
A jigsaw is the best method of cutting the sheeting panels. A fine toothed hand saw can also be used to cut the panels.
Jointing
Fully sealed joints are made using Advanced high impact PVC Silicone free gasket trim system which incorporates a co-extruded seal unique to Advanced. Joints can also be welded upon request.
Internal / external corners
Advanced PVC is normally thermoformed on site, so window and door reveals are neatly clad without an edge joint.
Fixing
Panels are fixed using a fully bonded method with a trowel for advanced adhesive (or gun applied polymer adhesive subject to wall substrate).
Advanced Panel Adhesive
This provides a quick and simple method to fit hygienic PVC panels to most substrates. This polyurethane adhesive is applied to the back of the panels or onto substrate to give a solid all over bond.
The adhesive is easy to spread and should be applied with a notched trowel (see diagram). To ensure a 100% transfer of adhesive, apply firm, even pressure to the complete surface area when the panels are offered to the wall.
