Group: gruppo Disano
Exterior wall light
Housing: In die-cast aluminium, complete with front frame with grid.
Reflector: Asymmetric in high-grade pressed, anodized and polished aluminium, 4/6µ thick.
Diffuser: Matt or clear tempered glass, 5 mm thick, silk-screen printed, impact-resistant (UNI EN 1250-1:2001 tests).
Painting: In several stages. First stage: black epoxy cationic electrocoating, resistant to corrosive and saline environments. Second stage: UV-stabilizing primer, and lastly rough finish with graphite acrylic coating..
Lampholder: In ceramics, with silver-plated contacts. Socket Rx7s.
Electric gear: 230V/50Hz power supply with thermal protection. Silicone wire terminated with quick connect clamps in admiralty brass, with fiber glass braid. 2P+T terminal block with maximum allowed lead cross-section of 2.5 sqmm.
Supply: When the fixture is opened, the front frame remains hooked to the housing by means of nylon cords for easy maintenance.
Standard supply: When open, the front frame stays attached to the housing by means of safety springs, for easy maintenance.
Equipment: Cable gland in fiberglass nylon Ø 1/2 gas thread (cable min Ø 9 max Ø 12). Retained steel screws.
Mounting: On wall, round pole or special column.
Regulations: Produced according to applicable EN60598-1 CEI 34-21 standards, IP65IK08 degree of protection according to EN 60529 standards. These products can be installed on normally inflammable surfaces.
Lamps: Complete with lamp JM-TS150.
Non-polluting louvre, ideal for installation in UNI10819 zone 1.