Group: gruppo Disano
Outdoor wall light
for outdoor use
Housing: In die-cast aluminium, complete with front frame with grid.
Reflector: Symmetric in pressed, anodized and polished 99.85 high grade aluminium, 4/6µ thick.
Diffuser: Matt or clear tempered glass, 5 mm thick, silk-screen printed, impact-resistant (UNI EN 1250-1:2001 tests).
Painting: In several stages. First stage: black epoxy cationic electrocoating, resistant to corrosive and saline environments. Second stage: UV-stabilizing primer, and lastly rough finish with graphite acrylic coating..
Lampholder: In white polycarbonate and phosphor bronze contacts. In ceramics, with silver-plated contacts.
Electric gear: 230V/50Hz supply with thermal protection (except versions FLC/MBF/SBP). Hard wire, cross-section 0.50sqmm (FLC), PVC-HT sheath, or silicone wire terminated with quick-connection admiralty brass clamps; double fibreglass braid insulation. 2P or 2P+T terminal block (maximum allowed lead cross-section: 2.5 sqmm).
Supply: When the fixture is opened, the front frame remains hooked to the housing by means of nylon cords for easy maintenance.
Standard supply: When open, the front frame stays attached to the housing by means of safety springs, for easy maintenance.
Equipment: Cable gland in fiberglass nylon Ø 1/2 gas thread (cable min Ø 9 max Ø 12). Retained steel screws.
Mounting: On wall, round pole or column.
Regulations: Produced according to applicable EN60598-1 CEI 34-21 standards, IP65IK08 degree of protection according to EN 60529 standards. These products can be installed on normally inflammable surfaces.
Non-polluting louvre, ideal for installation in UNI10819 zone 1.