Floor-mounted trash can / galvanized steel / for public areas
for public areas
The bearing structure of MASH is in steel EN10111DD11 sheet plate, T. 30/10, on which two steel EN10111DD11 plates are welded, T. 30/10. To the latter, on the lower part on the left, two pins (Ø 5x20 mm) are fixed: one acts as hinge whereas the other one serves to fix the back of the bin. On the right plate there is only one pin in order to fix the back of the bin as well. On the lower part of the structure, which has a 30x30 mm border, there are 4 M10 holes to fix the structure on the concrete base through appropriate bolts. The cover is in steel EN10111DD11, T. 25/10, and curved with a 590,7 degrees radius. It is welded to two uprights in steel EN10111DD11 sheet plate, T. 30/10, to which two steel EN10111DD11 sheet plates, T. 30/10, are fixed as well. On the left upright two pins are fixed, one acts as hinge, while the other one serves to fix the back of the bin. On the right plate it is fixed only one pin, which is used to fix the back of the bin as well. On the plates there are 4 M10 holes in order to link all the elements of the bin through appropriate screws. The door and the back in steel EN10111DD11, T. 20/10, are reinforced on the extremities by strong profiles, T. 30/10, furthermore, there are two borders 10 mm high and 5 mm wide, at a distance of 200 mm from the upper part and 200 mm from the lower one in order to strengthen the elements. In the inner side of the door and of the bin back there are two strong squared tube bars, 15x15 mm and T. 2 mm, in order to make the bin even stronger.