Steel rigid panel for underfloor heating
WP 2000
Lindner Armaturen GmbH
Low building height from 10 mm (without screed covering, flush for floor covering in middle bed method).
Widely independent from sub-floor - unevenness of up to 20 mm can be balanced out without further measures.
Excellent controllability through fast heat spreading, therefore short heating-up periods.
Highly energy-efficient due to low flow temperatures - up to 5 K lower than conventional underfloor heating, i.e. savings on heating cost of approx. 10 %.
Low material input - building is only charged, very little with dead loads of the system.
Quickly ready for floor covering within 7 - 10 days.
Ideal for modern low temperature heating, condensing boiler technology and heat pumps.
Widely independent from sub-floor - unevenness of up to 20 mm can be balanced out without further measures.
Excellent controllability through fast heat spreading, therefore short heating-up periods.
Highly energy-efficient due to low flow temperatures - up to 5 K lower than conventional underfloor heating, i.e. savings on heating cost of approx. 10 %.
Low material input - building is only charged, very little with dead loads of the system.
Quickly ready for floor covering within 7 - 10 days.
Ideal for modern low temperature heating, condensing boiler technology and heat pumps.
