Rigid expanded polystyrene insulation panel for roofs
ROOFSHIELD Springvale

Low cost, highly efficient, Roofshield keeps the heat where it needs to be Springvale Roofshield has been providing the effective, efficient, cost-effective solution to insulating a wide variety %u2018flat%u2019 roof constructions for decades, making substantial contributions to energy efficiency. An expanded polystyrene rigid board, Roofshield is supplied pre-cut to ensure efficient rainwater run-off.
It is available as both laminated and non-laminated insulation boards to receive a variety of waterproofing layers such as built up felt, mastic asphalt or single ply membranes. Roofshield boards are supplied in a single layer to reduce installation time and can be used in a variety of domestic, commercial or industrial flat or tapered roof applications including concrete deck, metal deck or timber board substrates. The products are supplied in 3 grades, EPS 100, EPS 150 and EPS 200 to meet all compressive strength requirements.
Several board sizes can be supplied to reduce wastage, and any fall gradient can be achieved. The specification of cut-to-falls insulation is a complex task that calls for experience. Springvale%u2019s technical department has been providing and designing cut-to falls systems for many years and can ensure that your roofs will operate efficiently, however complex the design. All boards are supplied sequentially marked, to make installation a simple task. Roofshield is as friendly to the environment as it is to the installer. CFC and HCFC-free, it has an Ozone Depletion Potential of zero; a Global Warming Potential of zero, achieves a BRE Ecopoints ratingof 0.043, will last the life of the building and is totally recyclable at the end of the building%u2019s life.