Skylight TECHNAL

The MX system allows sloped glazing to be created in Visible Grid or TrameVerticale.

These option gives specifiers the flexibility to construct sloped roofs, atria, canopies, valleys and pyramids, which are fully compatibles and visually consistent with the vertical façade.

MX Visible Grid
A special transom cap for the horizontal and vertical profiles reduce the collection of water on the slope.
The rafters and transoms are square cur and assembled using a penetrating transom principle.

MX Trame Verticale
There are vertical caps and silicone sealant on the transom with pressure blocks to prevent deflection under negative wind load pressure.
A minimum slope is available of 10° for single glazed units and 15° for double galzing.

Construction
The 8mm to 32mm infill is held by horizontal and vertical pressure plates for the visible grid system and by vertical pressure plates and horizontal pressure blocks for MX Trame Verticale.

Weather performance
Drainage is achieved from the transom ends through the rafters.
The grid system is glazed with an EPDM gasket to the inside and butyl tape to the outside. MX Trame Verticale has an infill gasket and silicone on the transoms.

More information...