The controller controls the complete treatment of a „Healing Clay Steam Bath” and all necessary components: Steam generator, exhaust fan, aroma pump, illumination, optional LED-RGB illumination and sound. The treatment is structured into three time steps:
Treatment time: The programme is activated by the start push-button on the outside of the cabinet. Then the room light is switched-off and the effect light (e.g. fiber optics or LED RGB illumination for light therapy) is switched-on. During this time the healing clay treatment (scrubbing and drying) is done.
Steam time : Afterwards the steam generator is activated and starts to produce steam on full power. The cabinet is filled with steam and the dry healing clay on the body gets wet.
Shower time : The illumination changes to red. A warm drizzle rain sprays on each guest from nozzles above the seats. This procedure is necessary for the pre-cleaning. The treatment stops after the shower. The effect light is switched-off, the room light and the exhaust fan are switched-on. The controller is ready for a re-start.
There is the possibility to operate the controller only on steam room operation. In this operation mode the controller controls the cabinet like a normal steam room with steam production, exhaust fan and aroma dosing.