|
|
The ELEACOME range of electric radiating surface systems :
Eléatram is an electric floor heating system used for total or partial heating in private houses, flats and service industries.
Its principle of operation : The floor is heated by a cable at constant power attached to a plastic frame and the combined unit is then laid on an insulating plate in PSE.
Its implementation uses a "wet" solution i.e. under a concrete slab or a fluid screed on which the floor covering will be laid.
|
|
SIPCP Twin heating mat with 1-sided connection
For complete heating (floor storage heating, partial storage and direct heating)
Laying width 90 cm
Sepentine heating conductor mounted on synthetic supporting net
Cold lead length 4 metres, 1-sided connection
For use in dry, humid and wet rooms
With PVC protective jacket for exceptional heat stabilization
Specific linear load max. 25 W/m
|
|
Underfloor heating suitable for fitting around the perimeter of an un-carpeted room which requires high-output heating with a fast response time. Typical applications are garden rooms and galleries, entrance halls, and traditional greenhouses and conservatories.
The heating system uses convectors, set in a duct and covered with grilles and works efficiently off existing central heating without fans or additional pumps. Marston & Langinger offers a design-layout service, and supplies heating convectors, baffles (to improve air circulation), alloy grille-supports, trims, and grilles in various sizes, combinations and patterns. In glass buildings with electric ventilators, a Marston & Langinger automatic controller can be used to operate both the heating and ventilation to give a balanced temperature, whatever the weather outside.
|
|
|
Honeywell Floor Heating systems consist of a Teflon insulated copper alloy resistance heating element sewn to a fiberglass mesh backing. The heating element is evenly spaced in 2” serpentine loops. It also delivers a faster, more even distribution of heat for improved homeowner comfort. The entire system is less than 1/8” thick allowing it to be easily installed under tile and stone without greatly affecting the floor height.
|
|
Honeywell Floor Heating systems consist of a Teflon insulated copper alloy resistance heating element sewn to a fiberglass mesh backing. The heating element is evenly spaced in 2” serpentine loops. It also delivers a faster, more even distribution of heat for improved homeowner comfort. The entire system is less than 1/8” thick allowing it to be easily installed under tile and stone without greatly affecting the floor height.
The fiberglass mesh backing helps to hold the heating element in place for easy, fault-free installation. It also allows the system to be covered directly by the thinset cement used to lay tile or natural stone flooring.
Full room heating systems generally consist of a single Honeywell heating “roll” of predetermined length. The system is placed in position using the easy-to-follow floor layout diagram provided with each kit, with a pre-attached lead that runs to a thermostat and/or junction box for power. No additional installation wiring is required.
|
|
|
Domocâble offers comfort d´une soft and uniform heat and d´un agreeably hot ground without cold zone and circulation to d´air. The temperature of surface of the ground does not exceed 28°C.
|
|
| ... products without information |
| |
|
|
