|
|
Electric heater equipped with a titanium resistance (3kw mono/three). Thermal overload protection (light signal) in case of overheating. ON/ OFF light switch. Mechanical thermostat to adjust temperature. Electric cable & switch.
|
|
¬ Swimming pool furniture heating installation. It uses night rate electricity in hotel complexes, sports centres, clubs, private homes, buildings, and so on.
¬ This energy is the most economical, safer, reliable and the least polluting.
¬ Maximum heating time is 8 hours (23h-7h is the normal night rate tariff). If you heat up for 24 hours a day, you should divide by 3 the power shown on the table manufacturers.
¬ This is the consumption during the coldest day. The rest of the time, the consumption will be lower than the one shown on one on the table.
¬ The information appearing in "Technical data" is only valid for outdoor swimming-pools when the outside temperature is not below 15ºC.
|
|
Boiler rooms SKP (SuperKit Pool furniture) associate a boiler
electric with a plate heat exchanger in INOX316L.
Heaters not being in contact with
water of pool, these boiler rooms can be installed on
all types of basin: chlorinated water, treatment by salt, water
of sea,... without fearing corrosion.
The determination of boiler rooms SKP is always the object
of a particular study according to the communicated data
at our research department.
The delivered apparatuses are thus "ready to pose" and easy with
to implement. |
|
The CLIMEXEL heat exchanger is designed to be
mounted in by-pass with a boiler or heat pump suppliers as
the heat source. It may be purchased as is or,
alternatively, pre-assembled with the circulating
pump and every other element required for its
operation contained within an ingeniously designed
housing.
This heat exchanger features spiral plates made
of titanium, a very stable metal, that generate an
excellent yield thanks to the large exchange surface
area.
The pre-assembled version of the heat exchanger
is ready to plug and play, it simply needs to be
mounted on the filtration circuit. |
|
Swimming pool furniture water heater from 6KW-35KW(single phase to 3-phase),With high quality titanium heater exchanger for pool water, anti-corrosion case,standard ISO water inlet/outlet connection,Larger screen LCD wire controller or panel furniture controller,air purger valve,anti-freezing protection, pressure prootection, easy open panel for easy maintenance. R407C/R410A Environmental protection gas.5~7 water temperature difference between inlet/outlet water. Low noise operation unit.
|
|
The air which surrounds us is inexhaustible and free. Each day the sun brings its heat to him. Because you do not have surface
necessary to pose its sensors POLYTUB, giordano another economic solution proposes to you: heat pump supplier GIORPAC.
The principal characteristic of an heat pump is to draw the calories contained in the air while consuming on average 1/4 to 1/3 of the energy which it brings. Thus when a GIORPAC brings 3 to 4 kWh to your pool furniture, meter EDF invoices you only 1 kWh.
|
|
The air which surrounds us is inexhaustible and free. Each day the sun brings its heat to him. Because you do not have surface
necessary to pose its sensors POLYTUB, giordano another economic solution proposes to you: heat pump supplier GIORPAC.
The principal characteristic of an heat pump is to draw the calories contained in the air while consuming on average 1/4 to 1/3 of the energy which it brings. Thus when a GIORPAC brings 3 to 4 kWh to your pool furniture, meter EDF invoices you only 1 kWh. |
|
Heat pump for heating maximum swimming pool furniture 50 m3, private basin.
Order by black box connected to the pump by a cable.
Guarantee 2 years.
Power supply 220 V. absorptive Power: 1,7 kw
Weight: 66 kg
|
|
| For each 1 kW CLIMEXEL consumes, it generates at least 4. This is among the highest yields available today. The explanation lies in its titanium plate heat exchanger: the exchange surface area of a plate is higher than that of a tube, hence more calories are captured and the yield is increased. Consequently, it is one of the most economical pumps available on the market. As regards titanium, this stable material is totally compatible with every type of water treatment, including salt electrolysis. |
|
Completely autonomous hot air generator designed for conditioning covered swimming pools furniture. This equipment can operate with heating gas oil, natural gas or liquefied petroleum gases (butane gas, propane gas).
These equipments function is to heat environmental air inside the premises by means of the thermal energy produced by the equipment.
The produced heat is driven to the premises that must be conditioned by means of a centrifugal fan.
The combustion products are extracted through a chimney in order to ensure that the driven hot air is exempt of smokes and bad smells.
The main features are as following:
-Heating gas oil, natural gas or liquefied petroleum gases operation.
-Cupboard made with galvanised sheet covered with polyester dust dried in the oven furniture at 200ºC.
-Combustion oven designed for obtaining a performance of 90%.
-Three-speed centrifugal fan.
-Electronic control with a display of the temperature driven to the premises.
-Environmental thermostat incorporated in the equipment.
-Air impulsion in elbow shape at 90º with double deflection grid incorporated on it.
-It incorporates a digital time-programmer for starting-up and stopping automatically the equipment.
-Extractible air admission filter.
FUEL:
Heating gas oil / natural gas /LPG
APPLICATIONS:
Covered swimming pools, events tents furniture, small industry and any premises with a volume between 750m3 and 1.075m3 approximately.
|
|
Today, solar energy is the only economic means which makes it possible to double the period of use and to improve comfort of the design pools. Range POLYTUB® adapts to all the situations (terrace, gardens, roofings, etc) and to all the budgets.
1 - POLYTUB S - For an installation on the ground
Flexible design solar collector POLYTUB "S" is particularly intended for the installations to measure.
The matter used (EPDM) in its manufacture brings the flexibility necessary to him making it possible to marry all surfaces whatever is their form (big lengths, roofs with several slopes, triangles, hillocks of ground, large terraces...).
Proposed in rollers, the POLYTUB "S" can be cut out to adapt to the type of surface you have.
2 - POLYTUB M - For installations on design roofing
Modular solar collector POLYTUB "M" is especially designed for installations on roofing.
The matter used (Polypropylene) in its manufacture, confers rigidity to him allowing a good behavior and an excellent esthetic aspect.
The originality and the quality of its design design allow a fast and simplified installation.
3 - Principle of operation of Polytub
Two types of connections are proposed: automatic or handbook, according to the typology of the pool and of its use.
|
|
Modular solar collector manufacturers POLYTUB "M" is especially designed for installations on design roofing.
The matter used (Polypropylene) in its manufacture, confers rigidity to him allowing a good behavior and an excellent esthetic aspect.
The originality and the quality of its design allow a fast and simplified installation. |
|
THERMAL
Solar heat and swimming pool water are an ideal combination. Water is an ideal heat buffer and ensures good heat storage. This keeps the water warm even on colder days. Combined with good covers this usually makes additional heating superfluous. HYDRODECK SOLAR BLINDS FURNITURE are an ideal solution particularly for private pools furniture. The combination of covering and heating leads to surprising results. Uncovered collector systems are the best choice for any pool. The POLYTUB EPDM absorber system for flat roofs and horizontal areas and the SUNCELL polypropylene panels furniture for sloping areas have proven to still operate perfectly after 20 years. Using professionally detailed mounting systems allows the rapid and correct construction of safe, professional systems. |
|
| ... products without information |
| |
|
|