Indoor detectors

... pointer built into the remote, provides accurate sensor selection for programming Sensor can be programmed with a laptop PC as well as with a remote Status LEDs facilitate sensor programming Each ...

The Lightcloud Dimmer/Sensor is an in-wall passive infrared motion detector and dimmer switch that can control remote circuits. The Dimmer/Sensor requires a compatible Lightcloud Controller or Driver and Lightcloud Gateway.

Width: 45 mm
Length: 140 mm
Height: 140 mm

... Building Regulations smoke alarms must be installed in all escape routes and high-risk areas, as defined in BS 5839-6:2019. These areas include living rooms, hallways and landings. • Photoelectric Technology – uses ...

... open contact) and NC (normally closed contact) 2-in-l, the other is normally closed relay output. It is idéal for typical indoor applications such as office, classroom, healthcare and other commercial areas. With Bluetooth ...

Active sensor with a micro-controller to mesure the ambient temperature and humidity, it is possible to apply as a socket to the different design standards.

Triggers alarm when smoke is detected The smoke detector has been developed for the Skycom CE control unit and is used to operate the smoke and heat extraction systems. This sensor must be fixed horizontally, ...

... correct gas sensor operation indicator / actuator testing function units may be linked to increase system capacity alarm warns against excessive gas concentration and cuts off gas supply alarm signal may be transmitted ...

Premium Door Sensor IR motion Can be used in supermarket, stores and a variety of people frequently through the small automatic door control occasions, can also be used in small space of the human body presence detection, ...

... strategy. These ZigBee sensors provide occupancy status allowing the implementation of advanced control sequences for HVAC equipment and other connected systems. ZVRCZCOC1 Specifications Type Ceiling Mounted Occupancy ...

Wireless, wall mounted CO2 sensor measures the dioxide level in the room (PPM). Sensor works as a unit controller and indicates the current status by means of a multicolour LED. Up to 20 wireless devices ...

... starts when the infrared sensor detects a presence in the room. When the person leaves the room the fan will continue to run depending on the timer setting (from 2 up to 25 min). In accordance with EN 60335-2-80. HT: ...

A sensor that measure both relative humidity and temperature. TECHNICAL DATA Item number 1002817