Prefabricated pillars

We manufacture reinforced concrete columns in square and rectangular geometries, with cross-sections ranging between 30 and 60 cm. Maximum lengths up to 30m. Depending on the needs of the project and/or its location, we can make columns ...

Recommended for construction in seismic zones, and to make the best use of space thanks to the compactness of sections with the same required performance, for structure ductility and beam-column node confining. It is suitable for infrastructure, ...

Columns are available in a range of sizes and finishes. Square, rectangles and circular columns can all be cast, to any size required for a specific job. Single storey columns can be easily cast, these units are generally 2.5 - 4 m ...

SPC Industries Sdn Bhd was established since 2003 with expertise in Precast Concrete Products manufacturing. SPC Precast Building System offer better building solution in meeting today's construction revolution. Benefits of Precast ...

... the design. Columns are divided in three parts: base, shaft and capital. An erection drawing is required for Columns and Pillars fabrication.

... them. The pillars carry the beams that support the slabs, which transmit loads that affect the whole area of influence of the pillar. The area of their cross-section is based mainly on the bulging ...

... and capitals are cast at the same time of the pillar itself. The non-standard brackets and capitals can be applied on top later on or manufactured from steel plates and later assembled after casting the pillar ...

SHORT DESCRIPTION:Pillars may be equipped with any kind of truss or device to support the beams, gantry cranes, jib cranes, plant engineering etc. The Mozzo Prefabbricati work bench is suitable for the making of pillars ...