Roof truss connectors

... installing ties on plated trusses (on the side opposite the truss plate) do not fasten through the truss plate from behind. This can force the truss plate off of the truss and compromise ...

... Simpson Strong-Tie can make a variety of flat and bent steel shapes, which include gusset plates for heavy timber trusses, custom ornamental shapes and retaining plates. Material 3 gauge maximum Finish Galvanized, black powder coat, Simpson Strong-Tie ...

... Used extensively throughout the world, this 1mm galvanised connector plate is used in the manufacture of the majority of the trussed rafters that our customers manufacture. The appropriate sized plate is specified by our sophisticated ...

... This 1.2mm galvanised connector plate is used in roofing situations where are a stronger connector plate than the 1mm M20 is required. A typical roofing example would be an attic truss where the non-triangulated ...

... and Irish construction industry. However, trusses are by no means limited to the relatively small spans involved in domestic roof construction. As a glance at the gallery on our website will show you, the MiTek design software enables ...

... situations where the overall height of a truss is too great for the safe transportation of the truss. The plates allow for the cap of the truss to be site fixed using nails through pre drilled holes ...

... CONCEALED TIMBER-TO TIMBER CONNECTOR • Three practical kits in different sizes designed for the most common applications. They can be used with small section beams for structures, gazebos and furniture • Excellent assembly tolerances, ...