Gas bain-marie stock pot 150 litres - Round kettle - AISI 316 L stainless steel heat diffusing base - 24.5 kW - Width 800 mm - Automatic fill and top-up for bain-marie - Safety pressure switch - Hinged and balanced lid - Hot and cold water mixer tap - Drainage by stop tap - Burners with safety device and pilot light - Electrical ignition by continuous sparking
Description
•Rounded front edge, kettle with surrounded board and
back plate with rounded internal corners.
•RoundkettlewithheatdiffusingbaseinAISI316Lstainless
steel.
•304 stainless steel clip, 20/10 thick.
•Double wall of the bain-marie 15/10 thick made of 304
stainless steel, and 30/10 thick for the base.
•Insulated by means of rock wool panels covered.
•304 stainless steel lid, 12/10 thick, hinged and balanced
by means of stainless steel springs.
•Handle with a knob made of insulated material.
•Water spout controlled by hot / cold water knobs located
on façade.
•Drainage by drain off valve diameter 40 x 49 (1 1/2") with
fold-down key, located on façade.
•304 stainless steel removable filter.
•Bain-marie water connection fitted with an “EA” check
valve complying with EN 1717 standard.
•Automatic fill and top up for bain-marie using electrovalve
and level sensor.
•Air bleed during initial pressure build-up.
•Calibrated safety device in case of excess pressure.
•Bain-marie drain tap located under the kettle.
•Vacuum release when ready for cooling.
Note: regarding the water supply to the appliance, the
installer shall comply with existing health regulations (e.g.
disconnector for certain regions).
Gas equipment
•Stainless steel sheet firebox.