Gas tilting bratt pan 50 dm² - 75 litres - 25 kW - Width 1000 mm - Rectangular kettle - Bimetallic heat diffusing base (8 mm + 2 mm) - Hinged and balanced lid - Electric tilting by actuator - Hot and cold water mixer tap - Burners with safety device and pilot light - Electrical ignition by continuous sparking
Description
•Top with raised edge on the back and sides kettle with
surrounded board to form a seal between the kettle and
the top (NF U 60-010 standard).
•Rounded front edge and back plate with rounded internal
corners.
•Kettle with rounded corners and bimetallic heat diffusing
base made of 8 mm mild steel and 2 mm of 304 stainless
steel on the cooking side.
•304 stainless steel clip, 25/10 thick.
•304 stainless steel lid,15/10 thick, hinged and balanced
by means of stainless steel springs.
•Handle with a knob made of insulated material.
•Water spout controlled by hot / cold water knobs located
on façade.
•Electrically tilted by a front-hinged actuator.
Options: -GN 1/1 Gastrostandard tray support hopper,
-water spout off-set on the right or left side.
-kettle 250 mm high,
-manual tilting.
Note: regarding the water supply to the appliance, the
installer shall comply with existing health regulations (e.g.
disconnector for certain regions).
Gas equipment
•Stainless steel sheet firebox, 20/10 thick, heat insulated
with high density insulating material.
•Two (SBM 35 G) or four (SBM 50 G) stainless steel linear
burners with thermocouple and pilot light safety device,
controlled by a 4 position tap.
•Electrical ignition by continuous sparking