{{#each product.specData:i}}
{{name}}: {{value}}
{{#i!=(product.specData.length-1)}}
{{/end}}
{{/each}}
{{{product.idpText}}}
{{#each product.specData:i}}
{{name}}: {{value}}
{{#i!=(product.specData.length-1)}}
{{/end}}
{{/each}}
{{{product.idpText}}}
Archi+ Pietra is a mineral plaster coat in powder for interiors. It is made of natural hydraulic lime NHL 3,5 (EN 459-1), aerial lime, specific aggregates and rheological modifiers carefully selected ...
NOVACOLOR SRL
Archi+ Pietra Intonaco is a mineral plaster coat inpowder for interiors. It is made of natural hydraulic lime NHL 3,5 (EN 459-1), aerial lime, specific aggregates and rheological modifierscarefully selected ...
NOVACOLOR SRL
Mirror is a lime-based stucco finish, with special additives to improve the gloss. It is made of “grassello” lime putty, selected inerts and rheological modifiers that ensure an easy-to-apply ...
NOVACOLOR SRL
... BIOMARC INTONACO DEUMIDIFICANTE [classified R/CS II (EN 998-1)] is made of pure and natural raw materials like natural hydraulic lime (NHL), pozzolanic ash and Roman lapilli, non-ground alluvial aggregate void of silt ...
... BIOMARC FINITURA DEUMIDIFICANTE [classified CS I (EN 998-1)] is made of pure and natural raw materials like natural hydraulic lime (NHL), non-ground alluvial aggregate void of silt and soluble salts, and are resistant ...
LIME AND CEMENT BASED FIBRE-STRENGHENED PLASTER CODE 9700010 INTOMARC is a premixed plaster composed of plumbing product and aerial binders, selected siliceous sand, fibres and specific additives to improve ...
Thermal spray cork-based plaster for inside and outside, suitable for thermal insulation and dehumidification. Composed by natural raw materials, the product is suitable for historic refurbishment and green building. Cork-based ...
DIASEN
... hydraulic lime, clay and diatomaceous earth, with high thermal insulation power, sound-absorbing, breathable and dehumidifying. Diathonite Evolution is a natural ecological premixed plaster, concrete-free, ...
DIASEN
Natural eco-friendly eco-compatible plaster with high-dehumidifying capacity, formulated with pure natural hydraulic lime, cork, clay and diathomeic powders. To be used for dehumidification and restoration ...
DIASEN
is a multipurpose single-coat plaster, a mixture of rock powder, aggregates and lime with a diluted polymer binder that gives it all its refined appearance with limited effects, as well as high resistance. MonoSoft is ...
... furniture. The advantages of the Creatina limestone coating: Natural VOC-free coating based on powdered limestone Endless possibilities for finishing textures and colours Easy to apply ...
... inspired by an age-old oriental technique. This ecological lime coating acts as a fungicide and a natural humidity and temperature regulator, giving a smooth, warm rendering with silky colours. The coating ...
Our PURE® Mineral Beton is a concrete coating enriched in lime. It allows the realization of interior decorations in polished concrete, vertically as well as horizontally (walls, wash-basins, technical ...
KoMalt.G Anti-shrinkage mortar made of lime, cement, calcareous sand and aggregates. Use for realise transpiring plaster on BIOVERD cork coating
Lime is used for centuries in construction. The highest quality of lime is its high permeability to water vapor, which can greatly reduce humidity and condensation problems in old buildings so mainly ...
Lime is used for centuries in construction. The highest quality of lime is its high permeability to water vapor, which can greatly reduce humidity and condensation problems in old buildings so mainly ...
VANDEX SUPER is applied to concrete where the active chemicals combine with the free lime and moisture present in the capillary tract, to form insoluble crystalline complexes. These crystals block the capillaries and ...
... evident humidity and salt deposits caused by capillary rising damp To create anti-condensation plaster Advantages Natural lime-based product, NHL according to EN 459 Suitable to coat all types of walls Suitable ...
Ultima light Dustbuster from Panel Rey® is a multipurpose joint compound that is easy to apply and has an excellent finish. It produces less dust in the air during sanding, reducing the impact in the Interior Air Quality. It is specially ...
Panel Rey
This product is designed for treating fasteners and finishing joints and corners between gypsum boards in walls and ceilings, as well as for applying finishings, textures and making small repairs to gypsum walls. It leaves a smooth ...
Panel Rey
Ultima Plus Compound is designed for treating fasteners, plastic a metal accesories and gypsum boards joints in walls and ceilings, as well as for apply finishings and textures. Is 20% lighter than traditional compounds and it offers ...
Panel Rey
Exterior walls Natural mat appearance 2 or 3 layers Granular finish
Lime coating (pasting) Interior walls Natural matt appearance Mineral colours 2 or 3 layers Granular air lime (powder) Exterior walls Natural mat appearance 2 or 3 layers Granular ...
Lime coating (pasting) Interior walls Natural matt appearance Mineral colours 2 or 3 layers Granular air lime (powder) Exterior walls Natural mat appearance 2 or 3 layers Granular ...
Lafarge concrete
This proprietary formulation offers superior weathering properties, is fiber reinforced to reduce shrinkage cracking and is concentrated for use with local sand, needing only the addition of sand and water.
... the substrate, therefore avoiding the formation, over time, of mould and bacteria. The product's natural composition, based on lime putty and granules of terracotta/stone, make it particularly adapt ...
OIKOS colore e materia per l'architettura
Description ProForm® BRAND FasTrack® Plus Compound is a fast-setting/hardening, sandable compound which is 30% lighter than conventional FasTrack. Thus, it requires less time and effort to work. Basic Uses FasTrack Plus Compound is ...
Weber Industries
is a lime based product with marble powders of various sizes, natural minerals and MICA. A Natural Wall to Smooth, to Touch and to Live in all its 169 Colors. Easily applied, it is excellent for filling and presents a ...
Giorgio Graesan & Friends
Tollens
Quality – The only mineral Lime Plaster with a matte aspect. Very tight finish without floating. Types of rooms :All living spaces, with our oil- and water-repellent Primer for humid rooms and kitchens. Not to be considered ...
RESSOURCE
... an ancient and traditional decorative plaster technique from Morocco. It is the original, natural, water-resistant Tadelakt lime from Marrakech, which is suitable for interior and exterior use. Tierrafino Stone tadelakt ...
... levelling smoothing mortar Leveller permeable to water vapour, with good workability. Suitable for: rough surface, lime and cement based surfaces and thermal insulating plaster (type Isolteco®), thermal ...
Edilteco
... after the characteristic building stone of Venice, the Istria polished plaster finish is made from a combination of slaked lime, recycled marble powder and special additives. Available in contemporary range of 72 colours, ...
Armourcoat USA
DESCRIPTION E115 I premixed hydro-repellant plaster is made with a mixture of cement, lime hydrates, selected sands, a hydro-repellant agent and specific additives that improve the adhesion and the workability. PACKAGING Humidity-resistant ...
LAGES
ROEFIX
... filtered hurd, +20% of fibers (in volume). Use of C015 hemp and lime mortar Insulated coating with first and second layer Sheeting and formwork paneling filling empty spaces Advantages ...
TECHNICHANVRE
How to choose this product
Lime plaster is suitable for use over stone, brick and terracotta, as it allows the underlying material to breathe. It slowly deteriorates if not periodically treated. Unlike other types, treated lime plaster leaves the supporting wall in good condition. This plaster has fungicidal and antibacterial properties.
Applications
Two types exist:
- Hydraulic lime plaster resists humidity and can be applied outside and inside, including in humid areas such as bathrooms and kitchens.
- Air lime, whether powder or paste, is used mainly for decorative purposes in dry, indoor areas.
How to choose
Consider the construction material that will be covered (earth, stone, bricks, etc.), the characteristics of the area in which the plaster will be applied (indoors, outdoors, dry, humid, etc.), its function (insulation, making slabs, decorative finish, etc.), its color, its texture, and the desired finish.
Please specify:
Help us improve:
remaining