Protection liquid waterproofing WALL INJECTION

for wallsiloxane

Product based on silanes and siloxanes, applied across the entire thickness of the wall via diffusion. Treatment of walls against rising damp. Effectivity after 48 hours. The pores and capillaries of the construction material remain open and the exchange of moisture with the substrate is maintained so the moisture already present may evaporate. 2 years in the hermetically sealed packaging, when stored in a dry, cool and frostfree place. Partly used containers may be resealed and used again after correct storage. To avoid the risk of spillage, always store and transport in a secure upright position. For the best result, remove skirting boards, plasterwork, wallpaper, paint, etc. up to one metre above the injection holes (or 30 cm above the moisture level), ensuring the moisture to evaporate easily from the injected areas during the drying process. Thoroughly inspect the joint pattern and repair where necessary to avoid leakage. Drill 10mm diameter holes into a horizontal joint at an angle of 10 to 15% at a height of 5 to 7cm from the floor, at distances of 12cm from one another and to a depth of up to 4/5 of the thickness of the wall. For walls thicker than 40cm, repeat the procedure on the other side of the wall. Position the injection cones approximately 50cm above each drill hole and insert the injection hose approximately 2 to 3 cm inside the injection space. Never insert the injection cone directly into the drill hole, as the distance between the reservoir and the treatment area is critical for achieving good penetration of the liquid in the wall.