Smoothing coating ULTIMA PLUS

jointingindoorfor wall

Ultima Plus Compound is designed for treating fasteners, plastic a metal accesories and gypsum boards joints in walls and ceilings, as well as for apply finishings and textures. Is 20% lighter than traditional compounds and it offers a higher coverage and efficiently reduces shrinkage and cracks. Features an excellent adhesion to substrate and its new green formula with low VOC content GREENGUARD certified. More coverage Smooth application Less shrinkage Optimum drying time Coverage : 7.8 ft2/lb. (depending on the desired finish) Availability : Box of 19 kg (3.5 gallons) General applicationPrecautionsAvoid dust from damp sanding. Use a mask and safety goggles. Dust resulting from sanding may irritate eyes, nose or throat. In the event of visual contact, thoroughly wash with water for 15 minutes until all particles are removed. If irritation persists, get medical attention. Do not ingest this product. KEEP OUT OF THE REACH OF CHILDREN. For more safety information refer to the MSDS on Panel Rey ́s website.Cover drywall joint with a thin coat of prepared compound and soak the reinforcement tape, leaving a coat of approximately 1/32"(1mm) under the tape. Drying time may vary depending on the weather conditions, the type of compound and the amount of water. Let dry before applying a second coat, which will cover 2" (5 cm) more in each side of the ends of the first coat. Let dry again and smoothly sand the section with compound. Finally, apply a third coat covering 2"(5 cm) more than the last coat in each side. Slightly sand, preferably with damp sandpaper for a greater quality in the finishing and lower breathable dust production.