Protective coating VITREX A+B

indoorfor wallfor concrete

Two-component epoxy enamel with high chemical resistance for thick coating of vertical surfaces. It is used to create continuous protective coatings in hydraulic engineering works. Description Two-component epoxy system having a good thixotropy for vertical thickness painting. Use Continuous protective coatings for hydraulic engineering works. Support The substrate must have a minimum compressive strength of 25 N/mm2 and a tensile strength of 1,5 N/mm2. Preparation of the support Concrete bottoms must be solid, dry (seasoned if newly built), leveled, absorbent, not polluted by oils, detergents, powders or other substances. Any discontinuities must be restored with suitable cement mortars. Apply a layer of primer consisting of epoxy formulation (ECOFONDO). Steel bottoms will have to be prepared by sandblasting. Apply suitable anticorrosive primer. Application At the time of application, combine the two components in a single container, mix carefully with appropriate equipment and mix for two minutes, taking care to take care of the walls and the bottoms of the cans, until consistency and uniform color are obtained. Quickly use the entire content. Apply the product with an airless brush, roller or spray. The theoretical consumption is about 300 gr/m2, for a recommended thickness per layer of 200 μm. Warnings VITREX coatings exposed to sunlight may fade or change color with a turn towards yellow; this fact does not affect the performance of the coating in any way. Between different production batches of the same color there may be slight differences: when possible use material from the same production batch.